Keeprite Flame Sensors

Keeprite Flame Sensors

Heil / Tempstar 1380679 flame sensor flame sensor part # 1380679 for use with Arco-Aire,Heil,Tempstar,Comfortmaker, Snyder General Igniter #1096048 kit. Also replaces old part number 1001358 ICP

41-401 hot surface igniter For Amana, replaces Amana parts D9918202, D9918202F and Norton 271A part # 41-401

031-01264-002 York/Luxaire Coleman circuit board For use with Air handler, model # N-AHB1206A. Replaces Texcas Instruments 6EH05-3 and old number 031-01264-001 Source 1

Robertshaw 780-910 hot surface ignition module Robertshaw 780-910 hot surface ignition module. Universal replacement for a large variety of hot surface ignition controls. Has built in diagnostic LED . Works with systems that sense the flame either through the hsi igniter itself or a separate flame sensor. for natural or LP systems, Single or 3 retries before lockout, 4 or 7 seconds ignition trial time, 17 or 34 second igniter warm up, 34 seconds or less pre-purge Robertshaw

41-405 hot surface igniter 41-405 Hot Surface Igniter, direct replacement for York(the ones with a flat filament igniter only)025-27766-000, 025-27774-000, 025-29043-000, 025-29050-000 also Smith HB 50018, Viessman 9302-094, Detroit Radiant 201D and others. *ceramic igniter base is 1 1/4" wide

41-408 hot surface igniter Rheem Criterion,Ruud & Weatherking. furnaces with HSI igniter. part #41-408 * ceramic base is 1 1/4" wide HSI Hot surface igniter,Exact replacement for Rheem part # 62-22441-01. Also replaces Trane part # B340039P01

Rheem Imperial hot surface igniter 62-22669-92 106-1034 igniter replacement kit for igniter 622266992 for Rheem Imperial RGED and Ruud UGED model series gas furnaces. Includes the igniter,mounting hardware,heat shield and gasket as shown.

B1401011 combo flame sensor & low voltage igniter Janitrol part number B14010-11S *by Honeywell same as Q3400A1024 and Q3400A1008 flames sensor and low voltage hot surface igniter assembly for PGB early models prior to serial#9607. Honeywell